Configuration

Configuring doctrine-dbal for TYPO3 CMS is all about specifying the single database endpoints and handing over connection credentials. The framework supports the parallel usage of multiple database connections, a specific connection is mapped depending on its table name. The table space can be seen as a transparent layer that determines which specific connection is chosen for a query to a single or a group of tables: It allows "swapping-out" single tables from the Default connection to point them to a different database endpoint.

As with other central configuration options, the database endpoint and mapping configuration happens within typo3conf/LocalConfiguration.php and ends up in $GLOBALS['TYPO3_CONF_VARS'] after core bootstrap. The specific sub-array is $GLOBALS['TYPO3_CONF_VARS']['DB'].

A typical, basic example using only the Default connection with a single database endpoint:

// LocalConfiguration.php
// [...]
'DB' => [
   'Connections' => [
      'Default' => [
         'charset' => 'utf8',
         'dbname' => 'theDatabaseName',
         'driver' => 'mysqli',
         'host' => 'theHost',
         'password' => 'theConnectionPassword',
         'port' => 3306,
         'user' => 'theUser',
      ],
   ],
],
// [...]

Remarks:

  • The Default connection must be configured, this can not be left out or renamed.
  • For mysqli, if the host is set to localhost and if the default PHP options in this area are not changed, the connection will be socket based. This saves a little overhead. To force a TCP/IP based connection even for localhost, the IPv4 or IPv6 address 127.0.0.1 and ::1/128 respectively must be used as host value.
  • The connect options are hand over to doctrine-dbal without much manipulation from TYPO3 CMS side. Please refer to the doctrine connection docs for a full overview of settings.
  • If charset option is not specified it defaults to utf8.
  • The option wrapperClass is used by TYPO3 to insert the extended Connection class TYPO3\CMS\Database\Connection as main facade around doctrine-dbal.

A slightly more complex example with two connections, mapping the sys_log table to a different endpoint:

// LocalConfiguration.php
// [...]
'DB' => [
   'Connections' => [
      'Default' => [
         'charset' => 'utf8',
         'dbname' => 'default_dbname',
         'driver' => 'mysqli',
         'host' => 'default_host',
         'password' => '***',
         'port' => 3306,
         'user' => 'default_user',
      ],
      'Syslog' => [
         'charset' => 'utf8',
         'dbname' => 'syslog_dbname',
         'driver' => 'mysqli',
         'host' => 'syslog_host',
         'password' => '***',
         'port' => 3306,
         'user' => 'syslog_user',
      ],
   ],
   'TableMapping' => [
      'sys_log' => 'Syslog'
   ]
],
// [...]

Remarks:

  • The array key Syslog is just a name, it can be different but it's good practice to give it a useful speaking name.
  • It is possible to map multiple tables to a different endpoint by adding further table name / connection name pairs to TableMapping.
  • Mind this "connection per table" approach is limited: If in the above example a join query that spans over different connections is fired, an exception is raised. It is up to the administrator to group affected tables to the same connection in those cases, or a developer should implement some fallback logic to suppress the join().

注意

Connections to databases postgres, maria and mysql are actively tested. However, mssql is currently not actively tested.

Furthermore, the TYPO3 CMS installer supports only a single mysql or mariadb connection at the moment and the connection details can not be properly edited within the All configuration section of the Install Tool.